Stevens Superspade Models
Stevens 38 Brute 3 blades with inside frame 25 degrees
Super duty fills 40" basket - Digs full round ball
One only available for immediate delivery Manual Hydraulic controls
$14,000.00 Cdn. Funds
Model sizes available on order 33" - 38" - 42"
Four Blade models available with inside or outside frame
3Blades made from 3/8" T1 steel
330" stroke with pointed blades
Frame centre made from solid 2" thick T1 steel with T1 steel 1/2" plate on bottom.
There are 1" thick steel plates on bottom of frame at tower locations securing all welds
Upper and lower hinges plates are also T1 steel 1" thick
Frame sits flat on ground and pushes ball into basket for perfect fit...minimal crimping
Wear sleeves are hardened ball bearing races.
Pin is made from 1045 steel and is softer than wear sleeves
and sleeves will not wear out first. Greasable.
T
Time proven toughest hinge in industry - same design for 25 years....no need to change
We have never had one wear out , honestly
Waranteed 5 years.
Universal adapter made from 3/8" T1 steel
Gate cylinder ears pins go right through solid steel frame, guaranteed to not break of in all situations.
Anti tip plate on top of hinge with wear sleeves makes this hinge super strong.
No gate lock required
Permanent wide opening with donuts securing all welds at tower locations.
Lift arm hooked to frame and to adapter....guarenteed to not break off even with mean operators
STEVENS SUPERTOUGH 3 BLADE
MODELS 34" - 38" - 42"
This is a Stevens Superspade Sandigger 33 - 3 blade inside frame at 30
degrees for digging in sandy soil. Notice how there is no hole opening for
soil to fall out. Dig trees 18" apart.
in
Stevens Superlite 38 Four Blades with inside frame
Notice frame with T-1 steel 1/2" thick welded to top and bottom of frame.
Also notice hinge assembly with 7 layers of T-1 steel overlapping
each other to stop hinge from tilting and wearing out.
All levels are greasable. This spade has dug around 15,000 trees
and frame and hinge still look like new.
Wear pads are nylotron full length of slide
This is top cap cylinder hookup. Notice how strong it is.
The cylinder ear has a backup mechanical fix eliminating any
chance of it breaking off in hard digging. It looks light but it is super strong.
This is a closeup of blade slide. It is made from a piece of tubing with
1/2" wall thickness. Notice multiple pass welding and additional support
gusset which secures blade to this slide assembly.
Sideview of hinge assembly showing layers of T-1 steel welded to frame